Responsive image

0086-137-3845-7991

Monday-Friday, 8am - 8pm
Feel Free to Call Us
Responsive image

info@mashiindustries.com

Write us a mail anytime!
Feel Free to mail us
NEWS
CONTACT US

Add: No.298 Mingguang Road,Yinzhou,Ningbo,China
Tel: 0086-137-3845-7991
WeChat / Whatsapp: 0086-13738457991
E-mail: info@mashiindustries.com

News
Your location:HOME > NEWS

Bearing Installation Notes

Release time:2019-04-04  Click:990

Preparation before installation
Bearings should be installed in clean, dry places, especially for miniature bearings, must be in a clean place, because any contaminated particles will have a great impact on the effectiveness of bearings. Before installation, all installation tools, shafts, bearing seats and corresponding parts should be clean, and any burrs and crushing should be removed as far as possible. At the same time, it is necessary to check the roughness, dimension and design accuracy of the joint surface of the shaft and bearing seat to ensure that they are within the allowable tolerance range. Do not unpackage the bearing before the installation preparation is completed to avoid pollution. Usually, bearings with grease lubricants do not need to remove rust inhibitors during installation; but for oil lubricants or in cases where grease and rust inhibitors can lead to reduced lubrication, anti-rust should be washed with benzene or petroleum solvents and dried before use. If the packing has been damaged or the bearing has been polluted, it should be cleaned and dried before use. Bearings with shields and seals can not be washed.

Installation
When the bearing is installed, equal pressure must be applied on the circumference of the ring end face to press the ring in, and no tools such as pins should be used to knock directly on the bearing end face in order to avoid damaging the bearing. In the case of small interference, the end face of bearing ring can be pressed by sleeve at room temperature, and the sleeve can be equally pressed by sleeve by tapping sleeve with a head. Hydraulic press can be used when installing in large quantities. When pressing in, it should be ensured that the outer ring end face and the shell shoulder end face, the inner ring end face and the shaft shoulder end face are pressed tightly, and no gap is allowed.

CONTACT

For more information about our products and services you can contact us at: 

Online Message